DNP3 to MQTT
Outstations over TCP or a serial line, read by class (AI3), as a device profile writes them (g30v5 idx0) or as group:variation:index. Design it in the editor, validate it, build the package and run it.
Typical use case
Substation or water-network RTUs whose points should reach a broker or a database beside the SCADA, without touching the SCADA's own DNP3 master.
The DNP3 driver deploys and runs in this release of the Edge Runtime. It has been tested against a simulated outstation, not yet against a real RTU, so treat the first commissioning as the verification.
Configuration approach
Points as the profile writes them
AI3, BI0, g30v5 idx0: the same spelling the device profile uses.
TCP or serial
Host and port, or a serial line, with the outstation and master addresses.
Quality travels with the value
A point that stops being readable is published as such, never as a repeat of the last good number.
Build a DNP3 to MQTT gateway
Create a project, define the device and its tags in the Edge Logic Editor, and download a runtime to test at the plant.